Holzma
HPL23 Rear Load Panel Saw

Machine ID: 007217

Year Mfr: 1999

Condition: As Taken From Service

Location: Tennessee

Voltage: 480V, 60Hz, 3Ph

Call For Price
Contact: Ralph Viegelmann
704-288-1904 Ext: 101
Submit an Inquiry on this product

This system has been dismantled and is ready to load on the truck.  Seller stated the saw to be in good running condition and cuts stacks of melamine chip-free.  
Model: Holzma HPL23/X/33/16
NOTE: Saw was upgraded form Cadmatic 2 on WFW to Cadmatic 3 on NT4.  A new PC was built to run it and put in a dust free cabinet mounted on the side of the saw.  The original unit is still there but not hooked up.
Specifications:129.9" (3,300 mm) Cutting length
5.9" (150 mm) max. main blade projection
40 HP (30 kW) Main & 3 HP (2.2 kW) scoring moto
Saw Carriage: Variable saw carriage with AC frequency drive, travel speed from 0 - 328 FPM (0 - 100 MPM), constant return of 328 FPM (100 MPM)
Pusher Fence: Electronically controlled, AC frequency drive overhead program fence with rack & pinion driven on both sides, Forward speed from 0 - 230 FPM (0 - 70 MPM), return speed of 230 FPM (70 MPM)
(7) Gripper clamps which open up to 5.9" (150 mm); 1st (2) clamps with (2) fingers and the others with (1) finger;(4) Trimming rakes for thin strips/scrap material are attached at the clamps
Operator & Machine Control:HOLZMA "CADMATIC 3.0 - REV. 009-0X.X" Controller with: Windows/NT4 operating system, displays cutting dimensions & patterns in moving colored graphics in real-time, 15" VGA Color monitor; 1.4 GB Hard Drive, data input by keyboard or 1.44Mb floppy disk drive;Features (4) serial interfaces, (1) parallel & (1) Ethernet interface, as well as a comprehensive error diagnostic system.Control panel w/CADMATIC housed in control cabinet mounted on double swiveling arm for ergonomic positioning by the operator;Possibility to setup for online download from office PC & label printing at the saw
Rear of machine:"Combi-rollers" with profile rails at 50 mm centers; (2) integrated front alignment units & cross-alignment before cutting to prevent offset panels within the same book
Front of Machine:Angular square fence in cross-cut section; 2 side pressure devices for cross-cutting are electronically & automatically controlled through the CADmatic & based on the material being processed
(1) air floatation table 111" x 26" (282 x 660 mm), (2) air flotation tables 85" x 26" (2,159 x 660 mm)
 

Manufacturer Holzma
Model HPL23 Rear Load Panel Saw
Year 1999
Voltage 480V, 60Hz, 3Ph
Machine Location Tennessee