2018 Northtech NT-MRS-14 N miltiblade rip saw

• Close link chain vs. open (no dust or pinch point)
• Oiler has twice the number of lube points (critical)
• The VS adjustment location on the 14N.
• Can cut up to 4 15/16″ with 14″ blade vs. the MRS-12 12″ blade 3-15/16”.
• * Can run 12″ as well on the MRS-14N*
• Bottom kickback fingers for added safety
• Saws, with proper tooling and material, can glue line

Specifications:

• Main Motor Hp. = 50 Hp.
• Voltage/ Freq. = 460 Volt 60Hz
• Phase = 3 Phase
• Amp Requirement = 35 Amps
• Feed Hp. = 2 Speed 1.5 / 3 Hp.
• Feed System = Feed Chain
• Feed Speed = 25 – 120 FPM
• Variable Speed = Variable Speed Pulley
• Elevation Hp. = 1/4 Hp.
• Elevation Style = Manual Wheel Adjustment
• Elevation Sys. = Jack Screw / Linear Guides
• Total Hp. = 53.25 Hp.
• Electronics = CE Approved Components
• Dual Voltage = Elevation Arbor Motors
• Control Voltage = 110 Volt
• Assisted Start = Wye-Delta
• Pass-Line = 33-1/2”
• Min. Length = 17-3/4”
• Min. Width = 1/2”
• Max. Width = 27-1/8”
• Min. Thickness = 5/16”
• Max. Thickness = 4-15/16”
• Arbor Rpm = 3570 Rpm
• Blade Size = 12” Tungsten Carbide Tipped
• No. of Teeth = 36 Tooth
• Blade Kerf = 3.5 mm
• Cleaning System = Brush on Chain
• Vertical Travel = 3/8” – 5”
• Dust Collection = (2) 6” @ 1962 CFM
• Arbor Diameter = 70 mm
• Hold Down Style = Pressure Plate
• Kickback Finger = (2) Top (1) Bottom Sets
• Emergency Stop = Push Button
• Rear E Stop = Push Button
• Safety Feature = Safety Interlock Switch
• Guarding = Full Cabinet Enclosure
• Oiler = Automatic Mechanical Oiler
• Low Oil Warning = Low Oil Shut-off
• Fence Type = Adjustable
• Fence Dims. = 103” Length
• Frame Const. = 5/16” Steel Construction
• Worktable Dims. = 27-1/8” x 64”
• Infeed Table = 13-3/4” x 103”
• Decible Rating = 74 dB
• Net Weight = 4402 Lbs.
• Gross Weight = 4694 Lbs.
• Machine Dims. = 67” x 58” x 71”
• Packaging Dims = 72” x 65” x 77”