This machine is coming out of a small shop that is closing down. Available immediately.
Manufacturer specs (to be confirmed):
- 1/2" Edge cap., panel thickness 3/8" to 2-3/8", min panel length 6 3/8" and 2-1/2" min. width
- Equipped with Quick heat-up glue system w/overhead hopper feed
- Automatic magazine for strip and coil stock
- 3mm PVC guillotine
- (1) driven plus 3-idler roller pneumatically controlled pressure section with digital readout setting.
- Workstations: Double motor end trim (.05 HP 12000 RPM) CHAMFERS
0 - 25 degree, top and bottom flush/raduis trim, bevels 0 to 25 degrees
(.75 hp 12,000 RPM) with insert knives for 3mm PVC radius; 2 motor
corner-rounding unit for top and bottom corners(0.5 HP 12,000RPM)
motors; top& bottom scraping for 2-6 mm radius, pneumatically controlled
blowoff nozzles; top & bottom buffing (0.25 HP 1,400 RPM). End trim &
flush stations have high freq. Motors w/electronic brakes and are equipped
with mechanical digital readouts for quick setup & adjustment
- Feed speed 46 FPM, 3 HP feed drive.
|Voltage||230V, 60Hz, 3Ph|