This machine has low hours. The current facility is not running the bander at this time.
Manufacturer specs (to be confirmed):
- Although the machine is capable of running thicker panels, the pre-mill cutter heads on this machine are only 42 mm work height.
- Universal automatic magazine for strip and coil feeding.
- Large coil table
- Quick melt granulate glue application system with 12-minute heat up time.
- Quick change glue tank
- Strengthened precutter for cutting PVC
- Double motor end trim unit with straight and chamfer capability. Chamfer up to 15 degrees. Program controlled indexing from straight to bevel end trimming.
- Fine trimming with servo motor program controlled indexing.
- Contour trimmung unit
- Scraping unit for rigid PVC edges. Program controlled indexing.
- Buffing Unit
- Electronic frequency changer for all trimming motors.
- Joint triming unit: Pretrim of the piece, 2-motors, vertical spindle adjustment, horizontal positioning
- End trim station
- Fine trim unit
- Contour trim unit
- Scraping unit with knives
- Top and Bottom buffing unit
- Corner Round
- Edgeband thickness: 0.4-12 mm
- Edgeband height: 12-60 mm
- Panel Length min: 160 mm
- Panel width min: 65 mm
- Panel thickness: 8 - 55 mm
- Feed Speed: 2-Speeds 16 m/min and 11 m/min
- Feed motor: 3 HP
- Joint trim unit: 3 HP
- End trim unit: (2) 1/2 HP
- Fine trim unit: 3/4 HP
- Profile trim unit: (2) 1/2 HP
- Machine length: 19'
- Machine width: 6'
- Approx wieight: 5,000 lbs
|Voltage||230/460 VV, 60Hz, 3Ph|
|Machine Location||Southeast USA|